Yeah the starter is charged it says i must prime the engine but i don’t know how ! It has one of these electric starters where you press a button on this hand held starter do i keep the glow plug on whilst starting ???
To get you started:- 1. Make sure all the pipes are in good condition and not leaking. 2. Prime the engine by pressing the little pump (normally near the carburettor). Only pump a couple of times - you don’t want to flood the engine. 3. Connect the glow starter 4. Have the throttle slighty open/low revs (via controller 5. Turn the engine over with the glow plug switched on 6. Disconnect the glowstarter 7. Off you go!!

Technorati Tags:




Comments

Name (required)

Email (required)

Website

Leave a comment

4 Comments so far

  1. darren w | 08 August 2009, 17:30

    is the glow plug starter charged up ? i had i nitro car and when i tried to start it with a flat glow plug starter it wouldnt fire .
    References :

  2. steve s | 08 August 2009, 18:14

    if you have home start call the r a c
    References :

  3. Rachel F | 08 August 2009, 19:01

    To get you started:-

    1. Make sure all the pipes are in good condition and not leaking.
    2. Prime the engine by pressing the little pump (normally near the carburettor). Only pump a couple of times - you don’t want to flood the engine.
    3. Connect the glow starter
    4. Have the throttle slighty open/low revs (via controller
    5. Turn the engine over with the glow plug switched on
    6. Disconnect the glowstarter
    7. Off you go!!
    References :

  4. kookie 92 | 08 August 2009, 19:21

    switch it in
    plug it in
    put battrys in

    i can tell ur thick…
    References :